Ryobi RMS-1221 Bedienungsanleitung Seite 18

GB
E. Bevel indicator
F. Sawdust extraction outlet
G. Lower Blade Guard
The blade guard helps protect your hands when the blade is in the raised position. To avoid binding on the workpiece,
it retracts as the blade is lowered.
H. Mitre saw handle
The saw handle has a trigger switch with a lock button. To lower the blade unto the workpiece, push down on the handle.
The saw will return to its upright position when the handle is released.
I. Trigger Switch
J. Mitre lock knob
K. Mitre scale
L. Turntable
M. Fence
N. Upper blade guard
9.1 UNPACKING AND CHECKING CONTENTS (Fig. 4)
The mitre saw is shipped complete in one box. Unpack all parts and check each item using the illustration and "Table of
Unmounted Parts". Make sure all items are accounted for before discarding any packing material.
WARNING:
If any parts are missing, do not try to assemble the mitre saw, plug in the power cable or switch on the machine until
the missing parts have been obtained and installed correctly.
ITEM
A
B
C
D
10. SAW MOUNTING
WARNING:
To avoid accidents, please read the following instructions carefully:
1. Before moving the saw, lock the mitre, bevel and powerhead positions. Unplug electric cable.
2. To avoid back injury, get help when you need to lift the saw more than 30 cm. Hold the saw close to your body. Bend your
knees so you can lift with your legs, not your back. Lift by using the hand-hold areas at the bottom of the base.
3. Never carry the mitre saw by the power cable. Carrying the saw by the power cable could cause damage to the insulation
or the wire connections resulting in electric shock or fire.
4. Position the saw so other people cannot stand behind it. Thrown debris could injure people in its path.
5. Place the saw on a firm, level surface where there is plenty of room for handling and properly supporting the workpiece.
6. Support the saw so the table is level and the saw does not rock.
7. Secure the saw in the desired location on a work bench. The base of the saw has four holes for mounting purposes. If the
saw is to be used in one location, fasten it to the work bench.
10.1 Blade specifications
Diameter: 210 mm
Bore: 30 mm
Maximum rotation speed: 5,500 rpm.
11. MOUNTING THE LOWER BLADE GUARD (Fig. 5 - 6 - 7)
WARNING:
To avoid accidents caused by unintentional starting or electrical shock, do not plug the saw in until all assembly and
alignment steps are complete. The power cable must remain unplugged whenever you are working on the saw.
NOTE: For compact shipment, the lower blade guard has been removed.
1. The mitre saw is equipped with a handle latch, used to lock the mitre saw in the lowered position. To change the position
of the saw, push the handle down slightly and pull the handle latch upwards.
TABLE OF UNMOUNTED PARTS
Saw
Lower blade guard
Dust bag
Thumb screw
QTY.
1
1
1
1
18