Nordmende RPS 3302 Bedienungsanleitung Seite 8

1. Technical Data
Generator:
Frequency range:
Scale accuracy:
Calibration check:
HF-output level:
Attennuation:
Internal resistance:
Crystal generator:
Operating modes:
AM-Modulation:
AN-internal:
AN-external:
FM-Modulation:
FM-internal:
FM-external:
AF-output:
Sweep generator:
Sweep generator 470 kHz
Sweep:
Output voltage:
Amplitude response:
Internal resistance:
Sweep generator 10,7 MHz:
Sweep:
Output voltage:
LW
IFAM
MW:
MW2
SW1*
SW2*
SWs*
IFe_*
SWs*
FM
140 ... 290 kHz
280 ... 520 kHz
500 ... 1000 kHz
950 ... 1700 kHz
1,7 ...3,4 MHz
28 ...5,2 MHz
5,0 ... 10,0 MHz
95 ... 17,0 MHz
17,0 .. . 34 MHz
85,0 .. . 110 MHz
+ 1% at the mid position of the electronic
fine tuning
Through beating with internal 1 MHz crystal
spectrum Calibration of the scale to 0,1 % at
nominated frequencies
30 mV (at 60 2) + 1,5 dB adjustable at meter
0... > 80 dB
60 Q
Frequency = 1 MHz + 1- 10-4
Continuously adjustable in all ranges
With 1 kHz-sinus (max = approx. 20... 80 %
according to range) :
Modulation bandwidth approx. 30Hz...30kHz
Input resistance approx. 1 kOhm
In ranges SW 3, IF/FM, FM
1 kHz sinus, continuously adjustable
(max. freq sweep approx. 20... 100 kHz
according to range)
Modulation bandwidth 30 Hz . . . 30 kHz
Input resistance approx. 1 kHz
At internal AM-FM modulation a 1 kHz signal
is available socket "Mod-extern"
Ri approx. 1 kOhm
Output voltage approx. 2 Vpp at 2 kOhm
To max. + 20 kHz adjustable
Approx. 200 mV at 150 Ohm
+ 1 dB at 10 kHz sweep
Approx. 150 Ohm (at max. output amplitude)
To max. + 1 MHz adjustable
Approx. 150 mVrms at 60 Ohm