Yedoo RUNRUN Bedienungsanleitung Seite 5

Installation manual
The assembly procedure
is the same for all models,
it only differs in details, see
accompanying pictures.
When tightening the
connections do not
exceed the specified
tightening torque.
3.
V-brake - Mula, Three, Kudu
First check that the front fork of the
scooter is aligned correctly (the V-brake
arms should be pointing forwards
towards the front of the scooter), then
release the brake cable from the guide.
In case of the Disc model, release the
brake wire from the housing and release
the brake arms.
EN
1.
Installing the wheels
Insert the quick release mechanism into
the wheel ensuring that on both sides of
the wheel the narrow ends of the springs
face the centre of the wheel.
4a.
Insert the wheel into the front fork so it
is exactly in the middle. Caution: When
inserting the wheel, ensure that the tyre
pattern points in the direction of rotation
when the scooter is rolling forwards
(on some tyres see direction arrow on
the side).
2.
Disc brake – Mezeq / Four
Put the separately packaged brake discs
on wheel hubs. Attach the rotor of the
disc brake so that the arrow on the rotor
would correspond to the rotation of the
wheel. Screw the rotor to the hub using
the attached key (torx).
When fastening the screws, make sure
you follow the sequence according to
the picture.
4b.
Direction
of rota-
tion
3
5
2
1
4
6
Direction
of rotation
6