Transportation And Storage; Cleaning And Maintenance - Royal Catering Rczc-1200E Betriebsanweisungen

2) The electric cable must not come near the hot surface of the machine. Please ensure that the
electric cable and the connector plug do not come into contact with water or any other liquids.
DO NOT use the device if the cable or the connector plug is damaged.
3) Please DO NOT touch the surface of the machine while it is in operation. DO NOT move the
machine while in operation.
4) Never touch the plug or cable with wet hands.
5) The temporary motor power of the device amounts to 80%. It is best to avoid extremely long
usage periods. In order to prolong the life of the machine the engine should rest for 20 minutes
after every hour of usage.
6) Before cleaning make sure that the plug is pulled out.
7) If the cotton candy turner doesn't make any cotton candy, please turn off the device and remove
burnt sugar with soft cloth.

8. Transportation and storage

Shaking, crashing and turning upside down of the device should be prevented when transporting it. Store it in a
properly ventilated location with dry air and without any corrosive gas.

9. Cleaning and maintenance

a) Unplug the mains plug and allow the device to cool completely before each cleaning, adjustment or
replacement of accessories, or if the device is not being used.
•
Wait for the rotating elements to stop.
b) Use only non-corrosive cleaners to clean the surface.
c) Use only mild, food-safe detergents to wash the device.
d) After cleaning the device, all parts should be dried completely before using it again.
e) Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
f) Do not spray the device with a water jet or submerge it in water.
g) Do not allow water to get inside the device through vents in the housing of the device.
h) Clean the vents with a brush and compressed air.
i) The device must be regularly inspected to check its technical efficiency and spot any damage.
j) Use a soft, damp cloth for cleaning.
k) Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or a metal spatula) because they
may damage the surface material of the appliance.
l) Do not clean the device with an acidic substance, agents of medical purposes, thinners, fuel, oils or
other chemical substances because it may damage the device.
CLEANING TIPS TO REDUCE BURNT AND VIBRATION ISSUES
A. When finishing the operation, slowly pour a small amount of water onto the spinning head
before switching it off to prevent burnt sugar residue.
B. Submerge the spinning head in hot water after each use or if vibration becomes extremely
severe to remove built-up sugar.
C. Clean sugar residue from the rest of the surfaces with a hot, damp cloth.
ATTENTION: Clean the device after use, regardless of whether it was operated only once or a number
of times. For efficient head cleaning, after use, pour approximately 150 ml of water (approximately
100 ml for model RCZK-420-W) into a hot and spinning head. The evaporating water will clean the
interior of the head. Switch the machine off. Once the head has cooled down, use a soft, damp cloth
to wipe it clean. Failure to follow these instructions may result in a build-up of caramelised sugar,
leading to defective operation of the machine (candy floss will not spin, in extreme situations the
head may be permanently damaged).
EN