6. Device use
ATTENTION! Applies to all models: A burning smell may be detected during first use. This is
normal and should disappear after a short time. Ensure that the room is well ventilated.
6.1.
Models:
1) When moving the device, press the handle downward and make sure that feet of the device are
above the floor (for models with trolley)
2) Push the On-button and keep the machine running for 1-2 minutes. Now check if the device is
ready for operation (the standing position of the machine needs to be adjusted in the event of
extreme vibration).
3) Push the "Heat" button ("switch for heater"). Wait at least 10-15 minutes to let the cotton candy
turner warm up. If sugar is poured into the head before this time is over, there will be a risk of
burning the sugar.
4) Work can be started after the cotton candy turner is properly warmed up - add a measuring
spoon of granulated sugar into the centre of the cotton candy turner.
5) After approximately 60 seconds you will have delicious cotton candy. Take the bamboo stick,
move it along the inner surface of the bowl and turn the stick around while doing so. As a result
you will get the typical cotton candy shape. (The bamboo stick may be cleaned with a dry cloth. It
is recommended that the stick is not entirely smooth, cotton candy sticks better to a rough
bamboo stick).
6) After having produced the amount of cotton candy you need, please do not switch off the device
but rather clean the cotton candy turner with water first. Keep pouring water into it while the
head of the cotton candy turner continues to rotate. After that you can switch off the machine.
The device should be cleaned after each use.
6.2.
Model:
1) Push the On-button and keep the machine running for 1-2 minutes. Now check if the device is
ready for operation (the standing position of the machine needs to be adjusted in the event of
extreme vibration).
2) Work can be started after the cotton candy turner is properly warmed up - add a measuring
spoon of granulated sugar into the centre of the cotton candy turner.
3) Cotton candy starts being produced almost immediately after adding the sugar. Take the bamboo
stick, move it along the inner surface of the bowl and turn the stick around while doing so. As a
result you will get the typical cotton candy shape. (The bamboo stick may be cleaned with a dry
cloth. It is recommended that the stick is not entirely smooth, cotton candy sticks better to a
rough bamboo stick).
4) After having produced the amount of cotton candy you need, please do not switch off the device
but rather clean the cotton candy turner with water first. Keep pouring water into it while the
head of the cotton candy turner continues to rotate. After that you can switch off the machine.
The device should be cleaned after each use.
7. Notes
1) Keep minors away from the machine.
EN