Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Specification
Power output:
Signal to noise ratio:
Distortion:-----------------
Input type:
•3.5mm stereo jack
Input impedance:
10K
Input sensitivity:
Satellites:
Subwoofer:
Adjustment:
Master volume
Separate bass control on subwoofer
Bass
unit:---
5.5 inch, magnetically
Mid-range
unit:
50mm x 90mm, magnetically
Treble
unit:-
3/4 inch PV dome tweeter, magnetically
Dimension:
Subwoofer:
Satellite:74
Net Weight:
Approx 5.3kg
Gross Weight:
Approx 6.6 kg
Warnings:
Please do not feed powered signal from another amplifier into the input ports of this system!
• Please adjust to a comfortable volume to avoid damaging your hearing and the system!
• Dangerous voltage inside the subwoofer / active speaker enclosure, please do not open the chassis.
Refer to qualified personnel for servicing.
Please remove the power plug if the system is unused for long period of time.
Please do not expose the system in rain or moisture environment.
• Please do not place vase or utensil full of liquid on the speaker.
5
RMS 2 x gw + 16W (THD
285
dBA
ohm
PC:
450mV±50mV
CD:
650mV±50mV
AUX:
250mV±50mV
60mV±30mV
control on wired controller,
shielded, 40hm
shielded, 40hm
shielded, 80hm
155 x 236 x 330mm (W x H x D)
x 282 x 89mm (W x H x D)
English
Not all speakers
function:
Please first check if the speaker wires are connected securely;
then check if the Line-in connectors
are reversed;
One satellite
speaker does not function
when playing
This kind of phenomena
is prone to happen on new computer systems that one satellite
does not function when playing CD, but system works fine when playing WAV formatted files.
This is mainly due to the fault connection of CD-ROM and sound card, that one channel of
signal is shorted to the ground.
Please refer to the manual of CD-ROM and sound card to adjust the wire connection.
System
does not work at all
1. Please check if power is connected, and if the wall outlet is switched on.
2. Please
check
if the
master
volume
is turned
3. Please check if the audio input cable is connected correctly
4. Please check if there is signal from audio source
Noise coming
from speakers
Amplifier circuitry of this product generates
little noise, while the background
some VCD/DVD
player or computer sound card are too high.
Please keep the system in active mode and remove the audio source, if no sound can
be heard at 1 meter away from the system, then there is no problem with this product.
Magnetic
interference
This system is complete
magnetically
shielded, and can be placed near TV or monitor.
But since magnet of the subwoofer
driver is large, some magnetism
when the system is too close to the monitor, and it is recommended
distance between the speaker system and monitor or TV set.
If you have any further
questions
or concerns
Please visit our website
at: www.edifier.com,
assistance
at: main@edifier.com,
If you prefer, you may contact
Toll Free: 1-877-EDIFIER
(334-3437).
Troubleshooting
check also if the audio source is at fault.
CD from computer:
to minimum
noise of
leakage is inevitable
to keep a 1 meter
regarding
Edifier Products
or email Edifier
Support
for further
us by phone,
English
6
Werbung
