" Plug the 20/24-pin connector into the socket provided on the motherboard. If
you have a 24-pin connection, place the remaining 4 pins in the correct position
before you plug the connector into the socket. If you
have a motherboard with a
20-pin connector, fold the additional 4 pins to one side.
٠ Now plug the 12V-P4 or Ρ8 connector for the CPU into the socket provided on
the motherboard.
5.
SAFETY FUNCTI.NS
All be quiet! power supplies have numerous safety functions. They are designed to
protect the power supply and the components connected to it against damage. If
one of these safeguards is triggered, ttie system will reboot or power off in most
oases. If this happens, you stiould immediately check the PC for errors.
For more info on troubleshooting see the "Troubleshooting" chapter.
The be quiet! Pure Power 11 series has the following safety functions:
٥CP (Over current protection)
If the load on tfie individual circuits exceeds the
specified limit, the power supply
is automatically switched off.
UVP (Undervoltage protection)
This safeguard Is triggered if ttie voltage on the circuits drops below a certain limit.
Ttie power supply is automatically switctied off in this case.
OVP (Overvoltage protection)
The overvoltage safeguard is triggered if ttie voltage in the circuits is too tiigh: the
power supply is deactivated.
SCP (Short circuit safeguard)
Ttie fuse protecting tfie power supply's secondary circuits prevents physical
defects of the power supply and the components connected to it.
OTP (Temperature safeguard)
In the case of excessive heat build-up in the power supply, the power supply
immediately and automatically switches off. You cannot switch it back on until it
has cooled down. Please ensure tfiat the PC has sufficient
cooling.
OPP (overload protection)
This safeguard is triggered if the total output of the power supply exceeds
the specified maximum load. This can tiappen if the output of power supply is
insufficient for the system (incorrectly dimensioned).
6