Webasto Next Kurzanleitung Seite 6

EN
2.2 Connection through a router with DHCP
Webasto Next - Router - Smart Meter
Webasto
Next
DHCP
2.2.1 Description
(This setup is not recommended by Webasto)
Transfer the IP address set on your home network's router (for the Smart Meter) to the charging
station's WebUI.
NOTE
The router may assign a new IP address after a restart. As a result, the connection bet-
ween the charging station and the Smart Meter can no longer be established.
2.2.2 WebUI Settings
For WebUI configuration see chapter 2.1.2.
2.3 Direct Connection with Static IP Address
Webasto Next - Smart Meter
Webasto
Next
Static IP Address
2.3.1 Description
■
Disable the Smart Meter's DHCP.
■
Disable the charging station's DHCP.
■
Set an IP address on the Smart Meter that is on the same network as the charging station.
■
Set an IP address on the charging station that is on the same network as the Smart Meter.
■
Enter the Smart Meter's IP address in the charging station's WebUI.
4
Router Smart Meter
(DHCP capable)
DHCP
LAN
Smart Meter
LAN
2.3.2 WebUI Settings
Select the NETWORK tab and deactivate DHCP. Under IP address (static) enter the charging
station´s IPv4 address and under Subnet mask enter the subnet mask.
Further WebUI configuration in the Load Management tab according to chapter 2.1.2.
5112410A_II_Next_Smart_Meter