Water Outlet Hose Connection - AEG Electrolux FAVORIT AAAUTO Benutzerinformation

28 Water connection
WARNING!
Warning! Dangerous voltage.

Water outlet hose connection

The end of the drain hose can be connected in the following ways:
1. To the sink outlet spigot, securing it to the underside of the work surface. This will
prevent waste water from the sink running into the machine.
2. To a stand pipe provided with vent-hole, minimum internal diameter 4 cm.
The waste connection must be at a height of be-
tween 30 cm (minimum) and 100 cm (maximum)
from the bottom of the dishwasher.
The drain hose can face either to the right or left
of the dishwasher.
Ensure the hose is not bent or squashed as this
could prevent or slow down the discharge of wa-
ter.
The sink plug must not be in place when the ma-
chine is draining as this could cause the water to
syphon back into the machine.
If you use a drain hose extension it must be no longer than 2 metres and its internal diameter
must be no smaller than the diameter of the hose provided.
Likewise the internal diameter of the couplings used for connections to the waste outlet
must be no smaller than the diameter of the hose provided.
When connecting the drain hose to an under sink
trap spigot, the entire plastic membrane (A)
must be removed. Failure to remove all the mem-
brane will result in food particles building up over
time eventually blocking the dishwasher drain
hose spigot.
Our appliances are supplied with a security device
to protect against the return of dirty water back
into the machine. If the spigot of your sink has a
"no return valve" incorporated this can prevent
the correct draining of your dishwasher. We therefore advise you to remove it.