Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
26
Installation
Installation instructions
Installation
WARNING!
Any electrical and/or plumbing work required to install this appliance should be carried out
by a qualified electrician and/or plumber or competent person.
Remove all packaging before positioning the machine.
If possible, position the machine next to a water tap and a drain.
Fitting under a counter (kitchen worktop or sink)
By removing the machine's worktop, you can install it under a close fitting sink unit or a
pre-existing top, providing the dimensions of the recess correspond to those shown in the
picture.
Proceed as follows:
1. Remove the machine's worktop by un-
screwing the two rear retaining screws,
pull the worktop from the back of the ma-
chine and slide out the front slots, lifting
the worktop.
2. Insert the machine after adjusting the lev-
elling with the adjustable feet.
When inserting the machine, ensure that the water inlet and drain hoses are not kinked or
squashed.
During all operations that involve accessibility to internal components the dishwasher has
to be unplugged.
Be sure that once the appliance has been installed, it is easily accessible for the service
engineer in the event that a repair is required.
If the dishwasher is later used as a free-standing appliance, the original worktop must be
re-mounted.
The plinth on free-standing appliances is not adjustable.
Werbung
Kapitel
Inhaltsverzeichnis
