Caberg TANAMI Bedienungsanleitung Seite 9

5. HOW TO REMOVE THE WASHABLE LINING
To remove the inner padding you can start from either the right or left side.
5.1 Remove the cheek pads by unfastening the 3 snap buttons (Pic. 8).
Remove the straps from both cheek pads and remove the two cheek
pads along with the neck protection.
5.2 Remove the lining by detaching the 2 studs on the rear side, then pull
it out gently by releasing the frontal fixing strips D.(Pic.9)
5.3 Pull out completely the lining.
6. HOW TO FIT THE WASHABLE LINING
6.1 Place the main liner padding inside the helmet.
6.2 Place the plastic frame in the front D and fix it to the seat attached to
the EPS liner. (Pic.10)
6.3 Hook the 2 studs in the rear side of the helmet.
6.4 Cheek pad insertion: thread the strap inside the two cheek pads. Slide
in the plastic insert between the EPS and outer shell and fix it to the
orange hooks (Pic.11); finally, snap in the 3 buttons on the rear of the
cheek pads. (Pic.12)
CLEANING THE WASHABLE LINING
•
Wash it strictly by hand with neutral soap and water (max.30°C).
•
Rinse it in cold water, do not wring it. Dry it at room temperature.
WARNINGS! Never clean the lining in the washing machine. Never use petrol
or other solvents to clean the lining.
ENG
9