Caberg TANAMI Bedienungsanleitung Seite 10

ENG
7. HOW TO INSTALL THE ANTIFOG LENS
7.1 Remove the clear visor as indicated in the instruction above.
7.2 Slightly flex the visor and place the antifog lens between the two pins
provided in the helmet shield. The silicon seal on the antifog lens
must make full contact with the helmet visor in order to avoid any
condensation forming between the helmet visor and the antifog lens.
7.3 Remove the protective film from the antifog lens.
7.4 Fit the helmet visor back on the helmet.
8. HOW TO REMOVE THE ANTIFOG LENS
8.1 Remove the clear visor as indicated in the instruction above.
8.2 Flex the helmet visor carefully until there is no more tension on the
antifog lens. Carefully remove the antifog lens from its position.
STOP WIND
The wind deflector limits the inflow of cold air from below.
9. STOP WIND ASSEMBLY INSTRUCTIONS
9.1 Insert and press the wind deflector fastening frame into the centre
position, making sure that all the anchoring pins are inserted correctly
into their respective slots. (Pic.13)
10