Initial Operation; Overload Protection - Janser BEPo UFS 115 N Betriebsanleitung

7

Initial operation

Risk of injury.
Always use the correct supply voltage.
Voltage of the power supply must match the information on the machine
identification plate.
Risk of injury.
Only use undamaged cutting tools.
Prior to any start-up check cutting tools for damages.
Switching on
Switching off
Locking
Switching off
7.1

Overload protection

The electric motor stops when overloaded.
Immediately reduce the load on the machine when it is overloaded. Let the machine cool down for
about 30 seconds at max. idle-running speed with no load.
30
o
Push forward the ON/OFF switch
o Release the ON/OFF switch
o Push the ON/OFF switch
it down for locking.
o Press the ON-OFF switch
return to the OFF position.
Attention
Attention
(Fig. 1/3).
(Fig. 1/3).
(Fig. 1/3) as forward as possible and press
(Fig. 1/3) down at the end; the switch will