Safety Instructions - Janser BEPo UFS 115 N Betriebsanleitung

2.2

Safety instructions

Risk of injury when the cutting tool is running.
Turn off the machine and disconnect it from the mains supply.
Make sure the machine is disconnected from the mains supply when carrying
out maintenance works, when changing the cutting tool or when setting the
bearing area.
Risk of injury.
Turn off the machine and disconnect it from the mains supply.
Remove power source, switch the machine off and make sure the spindle is
not moving before pressing the spindle locking button
Working safely with the BEPo UFS 115 N Twist is only possible if the operating and safety
instructions are carefully noted and strictly followed. Before using the machine for the first time,
you should have read and understood the operating instructions.
Never work without functional protective equipment (cover or cutting tool cover respectively).
Make sure the machine and guards are in good condition and work properly before using the
machine. Damaged parts or guards must be repaired by an approved service station, unless
otherwise stated in the operating instructions.
Proper functioning of the machine and the guards is only guaranteed, if original accessories and
replacement parts are used.
Only use original cutting tools approved by the manufacturer according to the specific case.
Regularly check cable and connector. When the line cable is damaged or broken, do not touch
the cable and disconnect the machine from the mains. The machine must be repaired by the
customer service.
Only use the machine with the drive unit rotating if the button to unlock the rotatable casing
2/ 9) is securely latched. Check the locking, if necessary.
Secure lose components before starting to work.
Only use the machine if the additional handle
two hands. Bring your arms to a position in which backstroke forces may be withstood. Never bring
the saw blade in a line with your body, always hold it to the side. Provide for a secure standing.
See also DIN EN 60745-2-5.
22
Danger
Danger
(Fig. 1/ 4) is fixed. Always hold the machine with
(Fig. 2/10).
(Fig.