Cutting Depth Adjustment; Cutting Height Adjustment; Approved Cutting Tools - Janser BEPo UFS 115 N Betriebsanleitung

6.1

Cutting depth adjustment

The cutting depth is adjusted by means of the spindle stop
o
Press down the lock lever
depth.
o After having adjusted the spindle stop
locking will be done automatically.
o By turning the spindle stop
adjusted precisely.
6.2

Cutting height adjustment

The cutting height is adjusted by means of the sliding spindle
For more information on installing the adjustable cover see chapter 11.5.
o Adjust the desired cutting height by turning the sliding spindle
6.3

Approved cutting tools

Designation
BEPo - HW cutting wheel wood (HW= carbide tool) / solid
(included in delivery)
BEPo - diamond cutting disk tiles / plaster
BEPo - HW cutting wheel solid wood
BEPo - HW cutting wheel laminate / MDF / chip board
BEPo - HW groove milling cutter 4mm
BEPo - groove milling cutter set)
(Fig. 1/6) to adjust the spindle stop to the desired cutting
(Fig. 1/5), release the lock lever
(Fig. 1/5) into the desired direction, the machine can be
(Fig. 1/5).
(Fig.
(Fig. 3/16) at the adjustable cover.
(Fig. 3/16).
Order No.
1115/054
1115/053
1115/055
1115/056
1115/057
1115/125
1/6). The
29