Closing The Door; Technical Data; Installation - AEG AGN71800F0 Benutzerhandbuch

Problem
dEMo appears on the Dis-
play.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.

TECHNICAL DATA

Dimension of the recess
Rising Time
Voltage
Frequency
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.

INSTALLATION

Positioning
WARNING!
If you are discarding an old appliance that has a lock or catch on the door, you must ensure
that it is made unusable to prevent young children being trapped inside.
The appliance shall have the plug accessible after installation.
Install this appliance at a location where the ambient temperature corresponds to the cli-
mate class indicated on the rating plate of the appliance:
Climate class
SN
N
Possible cause
The appliance is in demonstra-
tion mode (dEMo).
Height
Width
Depth
+10°C to + 32°C
+16°C to + 32°C
Keep pressed approximately 10
sec. the OK button since a long
sound of buzzer is heard and the
Display shut off for a short while:
appliance start works regularly.
1780 mm
560 mm
550 mm
21 h
230-240 V
50 Hz
Ambient temperature
31
Technical data
Solution