Werbung
3. Front axle assembly
Attach the front axle
on the front axle
with those on the tubes. Insert the M8*85 screws from the bottom to
the top, add the M6 washers and tighten the 6mm nuts using needle-nose pliers and a
screwdriver.
M6 Nut
Tube
M8*85 screws
4. Front wheel assembly
Flip the car body over. Using the wrench
remove the M12 washers on both sides and set them aside for later use. You do not need
to remove the M10 washers and bushes from the axle
with the M12 washers, then secure the nuts using the wrench
down to lock the wheel covers
M12 washer
Nut
Bush
xing tubes to the correct position on the frame. Match the holes
M6 Washer
M6 Nut
Tube
, remove the nuts from the front axle
onto the grooves of the front wheels
M10 washer
. Insert the front wheels
. While doing this, press
M10 washer
Bush
6
Needle-nose pliers
(Not Included)
Screwdriver
(Not Included)
, then
along
.
M12 washer
Nut
Werbung
