Inferum ROFES E01C Betriebsanleitung Seite 91

Table 5 shows the problems which you can solve independently. In case there are oth-
er problems occurred, please contact the manufacturer's representative. Do not attempt
any repairs by yourself!
Problem issue
No connection with the measuring unit
A message on the screen:
«Exit the program».
Connect the testing devise.
Enter the program. Start testing.
No signal from LED.
12. TROUBLE SHOOTING
• check the USB cable connection
• if the cable is connected, disconnect and replace
it by a similar one
• if the problem persists, contact the service
center
• check the USB cable connection
• if the cable is connected, disconnect and
change it to a similar one
• if the problem persists, contact the service
center
Table 5
Solution
EN
95