Lorelli BETWEEN Bedienungsanleitung Seite 4

o
O
o
USAGE
-When seating your baby for the first time, please practice adequately
actually placing your baby in the carrier or ask someone for assistance.
:Always secure your baby with a supporting
or tightening the carrier to your body.
-Your baby should not be loose in the carrier nor too tight to obstruct
breathing.
-Always fit the baby carrier onto your shoulders before putting your child in.
-Put on the baby carrier by passing your head and arms through the
shoulder straps.
- The position of the child to the carrier can be set with adjustment
length of the belts.
Before placing the baby, open the kangaroo and release the buckles.
"Face to face" front carrying
1. Fasten the back support buckle and then place the shoulder straps over
your shoulders. Picture 1
2. Sit down on a soft surface, e.g. a chair or bed. (Note: Unbutton the loop of
leg opening.) Picture 2
3. Carefully slide your baby into the carrier facing in with both legs through
its own leg opening. (Note: For small baby, button up the loop of leg
opening.) Picture 3
4. With one hand holding your baby, fasten the two sides of the head support
buckles with the other hand. (Note: Make sure your baby's arms are through
the arm holes.) Picture 4
5. Stand up and make adjustments for snugness (Note: Before releasing
your hold on the baby, make sure that all buckles are securely
fastened.)Picture 5
6. Done. Picture 6
Attention: The setting is correct when the baby's head is resting on your
chest.
Attention: Make sure that there are no buckles and straps behind baby's
backand that baby's legs are placed in the correct openings.
"Forward facing" front carrying
1. Fasten the chest/back support buckle and then place the shoulder straps
over your shoulders.Picture
2. Sit down on a soft surface, e.g. a chair or bed. (Note: Unbutton the loop of
leg opening.) Picture 8
3. Carefully slide your baby into the carrier facing out with both legs through
its own leg opening. (Note: For small baby, button up the loop of leg
opening.) Picture 9
4. With one hand holding your baby, fasten the two sides of the head support
buckles with the other hand.
(Note 1: Make sure your baby's arms are through the arm holes.
Note 2: For small baby, fold down the head support until
blocked.)
5. Stand up and make adjustments for snugness (Note: Before releasing
your hold on the baby, make sure that all buckles are securely fastened.)
Picture 11
6. Done. Picture 12
Attention:Make sure there are no buckles or straps behind baby's back and
that baby's legs are in the correct openings.
WARNING! Fit and adjust the leg openings for the child till their minimum
size of 100 mm so that the child cannot slip out of them. The minimum size
of the leg openings and the position of the child to the carrier can be set with
adjustment of the length of the belts.
CLEANING
Cleaning: Please, refer to the baby carrier label. After each wash check
that the fabric and seams are not worn or damaged. Wash by hand, water
temperature 300. Do not iron. Do not dry clean. Do not bleach. Do not
tumble dry.
Maintenance: Check the seams and baby carrier regularly to ensure that
they are not worn or damaged and that no part is missing. If any part is
worn or missing do not use the product!
AND ADJUSTMENTS
hand at all times while buckling
position
position
7
Picture 10
AND MAINTENANCE
before
of the
baby's face is not