TDK relyon plasma piezo brush PZ3 handheld device Betriebsanleitung Seite 8

1.2 Information and obligations for the operator
•
The system may emit interference.
- The system has been tested in accordance with EMC legislation.
- The operator must verify and assure electromagnetic compatibility with other
electrical and electronic equipment in the immediate vicinity of the system.
•
Ensure that:
- Operating personnel have read and understood these operating instructions.
- Anyone working near the device is made aware of the dangers and is provided with
the necessary protective equipment.
- Repairs are only carried out by qualified persons.
•
In particular, make operating personnel aware of the safety instructions in this
document.
•
Always keep the system in fully functional condition.
•
Any modifications made to the device will invalidate the operating license and the
warranty. Exception: Such modifications are expressly authorized by the manufacturer.
1.3 Impermissible operating conditions
The device must not be operated under the following conditions:
•
In explosive (Ex) zones
•
In areas with severe build-up of dust
•
In environments where the humidity is too high (see chapter 3 Technical data )
•
At altitudes of more than 2.000 m above sea level
•
Where there are strong vibrations
1.4 Emissions
The connected device produces the following emissions:
•
Ozone (O
Plasma gas
Air
Note!
As a precautionary measure, we recommend an extraction system with about 100 m³/h in
the direct vicinity of the plasma outlet.
8
)
3
Gas flow
approx. 8 l/min
Ozone
< 0,1 g/h
BA-PZ3_ML / F0354402