HP DesignJet Z2600 PostScript Einführende Informationen Seite 6

Message or code
61:01
62, 63, 64, 65, 67
63:01
71.04
74:04
74.1
74.8:04
79:03
79:04
81:01, 86:01
94, 94.1
Power specifi cations
Maximum power
Frequency
Input voltage
Maximum current
Recommendation
The fi le format is wrong and the printer cannot process the job. Check the graphic
language setting of your printer. If you are sending PostScript from Mac OS over a
USB connection, select ASCII encoding in both the driver and the application. Check
for the latest fi rmware and driver releases.
Update your printer's fi rmware.
The printer has failed to get an IP address. Connect to another network or change
the IPv4 confi guration.
Out of memory. To avoid this, in the HP-GL/2 and HP RTL driver select the
Advanced tab and then Send job as a
The fi rmware upgrade has failed. Press
Try the fi rmware update again. Do not try to use your computer while the update
is in progress.
The fi rmware upgrade has failed. Your fi rmware fi le may be incorrect; try to
download it again.
Restart the printer.
Update your printer's fi rmware.
Follow the instructions on the front panel. You may be asked to run a test
procedure and write down a numeric code before contacting your support
representative.
Restart color calibration.
120 W
50/60 Hz
~100–240 V
2 A
bitmap.
OK and try again.
Introductory Information 5