HP SD Pro 44-Zoll-Scanner Einführende Informationen Seite 7

10. Press the Scan to file
multipage format, press the Add page button and, after adding the last page of the job, press Save button.
Scanner maintenance
You should perform scanner maintenance once a month to maintain optimum scan quality. This routine maintenance
involves cleaning the glass plate and the scanning area, and calibrating the scanner. It is important to clean before
calibration.
1. Turn off the scanner and disconnect the scanner power cable.
2. Open the scanner lid.
3. From the front of the scanner, press down the lid while pushing the two lever buttons on the rear of the lid towards
the center of the scanner until they unlock.
4. Holding the lid from the front, pull it up to expose the scanning area for cleaning.
5. Gently wipe the glass plate and the entire scanning area, including the main cover and the roller, with a lint-free cloth
dampened with a mild, streak-free, glass cleaner.
Do not use abrasives, acetone, benzene, or fluids that contain these chemicals. Do not spray liquids directly onto the
scanner's glass plate or anywhere else in the scanner.
6. Dry the glass completely using a separate clean, dry, lint-free cloth such as the one provided with the maintenance
kit.
7. Turn on the scanner.
8. Select the Setup tab, then
9. The Calibration Wizard guides you through the procedures of scanner alignment, stitching, and calibration. To
calibrate the scanner, you need the maintenance sheet that came with your scanner.
Software error messages
Under the following circumstances, a warning message may appear on the panel PC touch screen, advising the user to
perform maintenance:
• Scanner maintenance has not been performed within the last 30 days.
• The condition of the glass plate has deteriorated beyond an acceptable level.
• The condition of the original background has deteriorated beyond an acceptable level.
If you see any of these warnings displayed on the panel PC touch screen, consult the User's Guide for information on
recommended maintenance procedures.
button to start the scan-to-file process and save the image. In case you have selected PDF
Options > Scanning > Calibrate.
Introductory Information