Beko RHP 6320 B Bedienungsanleitung Seite 9

3 Operation
3.1 Check before turning on the
machine
• Check if the power wire is under good
condition.
• The product adopts 220-240V AC
power supply, before use, please con-
firm if the rated current of the power
socket meets the local requirements
with safe grounding device, otherwise,
please replace it with the qualified
socket.
3.2 Put the machine on the flat
place
Uneven place may possibly cause the
turnover switch at abnormal position,
then the heater can't work after turning
on, therefore, please put the heater on
the flat place, at least the surface below
the base of the heater must be flat.
3.3 Temperature control knob
Insert the plug into the power socket,
then turn the Temperature Control knob
clockwise, when hearing the "poop"
sound (it means the temperature con-
troller is on), adjust the Temperature
Control knob to the desired temperature
level.
PTC Fan Heater / User Manual
3.4 Power selection knob
1
2
Turn the Power selection knob to select
between 4 functions: Low 1200W(LOW),
High 2000W(HIGH), Low 1200W Swing
(LOW SWING), High 2000W Swing (HIGH
SWING).
3.5 Turn off the heater
• Turn the Power selection knob to ''0''
position.
• Turn the Temperature Control knob an-
ticlockwise to the initial position.
• Remove the power plug, store the
heater after the entire machine has
become cool.
3.6 Safety protection
• Overheat protection: When the tem-
perature in the heater is too high due
to abnormali-ty in the use environment
or improper use, the thermostat device
can automatically cut off the power
and the heater stops working. After the
whole heater is cooling, the heater can
return to the normal use after removing
the abnormality.
• Inversion protection: When the whole
heater is inverted, the safety system
will automatically cut off the power,
and return to the work state before in-
version after the body is placed upright.
0
1
2
9 / EN