Raddy DT5-W Benutzerhandbücher Seite 4

Q:【
】button
R:【
】button
S:【
】button
T:【
】button
U:【Alarm on/off 】Toggle Switch
V:【Light/snooze】touch keys
W: Wireless charging center location
Remote sensor------
1: LCD
indicating lamp
2: Transmit
3: Wall mounting hole
4: Battery compartment cover
5: Temperature unit switching button
6: Manual pairing transmit button
7: Channel switch
Initial operation
 Open the main unit battery compartment cover
 Insert CR2032 batteries observing polarity ("+" and " –" marks), If there is battery insulating
sheet, just pull out the insulating sheet.
 Insert the adapter's Type-C connector into the corresponding socket on the back of the
product, then plug the adapter into an AC outlet for power.
 Enter RF pairing mode after the screen is on, this process lasts for a maximum of 3
minutes and will displayed by a flashing reception antenna symbol
number" .
During this time, open the remote sensor battery compartment, set the channel switch to
position "1", insert 2 x AAA batteries observing polarity ("+" and "–" marks), and close the
battery cover.
 If there are multiple remote controls, according to the same method, push the channel
DT5-W User Manuals
4
next to "channel