Sharp XG-NV4SE Serviceanleitung Seite 5

XG-NV4SE etc.
XG-NV5XE
XG-NV51XE
Turn off the main power switch. (Fig. 1)
Disconnect the AC power cord. (Fig. 1)
Screw x 2
. Remove the filter housing holder. (Fig. 2)
. Put a new filter in the housing. (Fig. 3)
—
Onrhwr—
Turn off the main power switch.
Filter housing
AC power cord
holder
oe
Fig. 2
Fitting the special-filter base (for stationary use)
(Procedure)
1. Turn off the main power switch.
2. Disconnect the AC power cord.
Screw x 3
3. Place the projector upside down as shown below.
j Washer x 3
4. Fit the filter base, referring to the figure below.