Placing The Child In The Swing - Caretero Raffi Bedienungsanleitung

SEAT ASSEMBLY
3
Insert the tips of the front seat frame tubes in the openings on the sides of the seat base (E) until the tubes are
locked in place ( 1.1 ).
IMPORTANT: After installation, the seat frame tube should face downwards as in the picture to the right (1.2).
Flip the seat upside-down. Attach the lower part of seat support to the seat base with screws (2.1) (1 ) - the longer
ones should be attached through the support tube and (2) - the shorter ones should be attached through the side
plates (2.2).
Put the upholstery on the seat frame (3.1). Then attach the tray onto the seat (3.2), connecting the side locks of the
tray to the sides of the seat base ( 3.3).
4 SWING FRAME ASSEMBLY
Insert the feet onto the tips of the leg tubes (4.1)and attach them with the screws (3) (4.2).
Connect (5.1) the right leg with the right frame tube (A) and the left leg with the left frame tube (B) (5.2). Before
attaching the right frame tube with the right tube of the control unit, please connect the cords found in the tubes (C1)
(6.1), then connect the tubes (C2) (6.2).
Connect the left frame tube with the left tube of the control unit ( D) ( 6.2).
5 CONNECTING THE SEAT WITH THE CONTROL UNIT
Connect the seat support tube with the central control unit tube (7.1) and attach them with the screw (4) (7.2).
6

PLACING THE CHILD IN THE SWING

Unfasten the harness by pressing the button on the harness buckle. Move the harness straps to the sides (8.1).
Place the child in the seat as shown in the drawing. Lock the side strap tongues in the harness buckle until you hear a
'click' (8.2). The harness straps length can be adjusted with the adjustment rings on the straps.
CONTROL UNIT FUNCTIONS
7
SWINGING FUNCTION
There are 5 speeds of swinging available.
The control lamp will light on when the swing on/faster button is pressed. When the same button is pressed
repeatedly, next lamps will light on, indicating the increase of swinging speed.
Analogically when the swing off/slower button is pressed repeatedly, the lamps turn off until the swing is brought to full
halt.
TIMER
There are 3 timer settings available.
One press of the timer button will set the timer to 8 minutes, two will set the timer to 15 minutes, three will set the
timer to 30 minutes. The chosen option is indicated by one, two or three timer lights turned on.
After time measured by the timer ends, the swing will stop to preserve electricity. When the swing is turned on without
the timer option, it will continue to work until manually switched off or until the batteries are depleted.
MUSIC
Press the music button to start the music playback. Press the button again to turn the music off.
Press the music change button to play the next tune. This button is also used to change the volume of the music
played.
SOUND EFFECTS
There are two additional buttons to turn on/off flowing water and bird tweet sounds. These sounds will help in
calming the baby and putting it to sleep.
14