Cleaning And Maintenance; Cleaning The Heating Element; Replacing The Fuse; Storage - EuroLite NB-60 ICE Bedienungsanleitung

We recommend a frequent cleaning of the unit, in particular the output nozzle. Please use a soft lint-free and
moistened cloth for the outside of the unit. Never use alcohol or solvents! Unplug the machine before cleaning.
Do not allow the fog liquid to become contaminated. Always replace the caps on the fog liquid container and the
fog machine liquid tank immediately after filling.
There are no serviceable parts inside the device except for the fuse. Maintenance and service operations are only
to be carried out by authorized dealers. Should you need any spare parts, please use genuine parts.
If defective, please dispose of the unusable device in accordance with the current legal regulations.
Should you have further questions, please contact your dealer.

Cleaning the heating element

The heating element should regularly be cleaned every 40 operational hours in order to avoid clogging. Use fog
machine cleaner available at your dealer. All fog machines are prone to clogging due to the thick consistency of
fog liquid and the high temperature at which it vaporizes. However, a properly maintained fog machine should
provide years of reliable use.
Procedure:
• Fill cleaner into empty tank. Run the machine several times in a well-ventilated room only. The number of
repetitions depends on the pollution level of the vaporizing elements.
• After use, clean all remaining cleaner and rinse the tank thoroughly.
• The Eurolite fog fluids we recommend are non-hazardous to the environment and can be disposed of via the
sewage system.

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating. Before replacing
the fuse, unplug mains lead.
Procedure:
• Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
• Step 2: Remove the old fuse from the fuse holder.
• Step 3: Install the new fuse in the fuse holder.
• Step 4: Replace the fuse holder in the housing.

Storage

It is recommended to operate the machine at least once a month with a warm-up period and a few minutes of fog
emission. Prior to storage, run cleaning fluid through the system as described in the cleaning regimen above. This
will help avoid any particles condensing inside the pump or heater.

CLEANING AND MAINTENANCE

18 • EN