blum SERVO-DRIVE uno Bedienungsanleitung Seite 14

SERVO-DRIVE uno
Structural changes and spare parts
Structural changes and replacement parts not approved by the manufacturer affect the safety and
functionality of SERVO-DRIVE uno and are, therefore, not allowed.
■
The condition as supplied to customer may not be changed.
■
Only use original spare parts from Julius Blum GmbH.
■
Blum components are the only devices that should be connected to the Blum transformer.
■
A max. of 2 drive units may be used per Blum transformer.
■
Please make sure that the Blum distance bumper is attached.
Assembly
■
All national standards must be followed for SERVO-DRIVE uno assembly. This includes, in particu-
lar, those related to the mechanical safety of moving parts and electrical cabling.
■
The device may only be connected to a power supply that corresponds to the type and frequency
listed on the serial tag (see Blum transformer).
■
No damaged parts should be used.
■
Sharp edges may damage the cable.
■
The total length of the cable should not exceed 2 m.
WARNING
Danger of electric shock!
➢ Never open a Blum transformer.
■
Never take apart a drive unit.
■
Make sure that moisture cannot penetrate the Blum transformer and drive unit.
■
Before the installation of SERVO-DRIVE uno make sure that there is enough space (min 44 mm)
behind the pull-out back in the cabinet. By cutting out the cabinet back panel you may win
additional space in the cabinet.
4
BA-140/1ML-A