Adler europe AD 7968 Bedienungsanleitung Seite 5

Do not use hot water. Never refill water during operation. Pour the essential oil vertically into the water tank. (FIG.
2B)
The recommended dosage is 2-3 drops of essential oil for a 100 ml tank.
4. Attach the splash guard (FIG. 1). Attach the cover (B) to the base. (FIG. 2C)
Note: The cover must be closed to use the product.
5. Connect the USB cable: (FIG. 2D)
- to the USB power adapter you already have at home, then plug the power adapter into a power outlet
or
- to the USB input of your computer / power bank.
6.Two-button operation:
Power button / mist spray button (N):
- First press: continuous mist with alternating 7 RGB LED colors.
- Second pressing (flashing twice): intermittent mist generation (15 second intervals) with alternating 7 RGB LED
colors.
- Third pressing: Turning off the device (mist generation and lights are stopped simultaneously).
Backlight button (O):
- First press: alternating 7 RGB LED colors.
- Second press: continuously illuminate with the last lit color.
- Third press: mode imitating the natural light of a burning candle .
- Fourth pressing: Turning off the backlight.
7.If there is no water in the water tank (C), the diffuser will be turned off automatically.
8.The product cannot be used if there is no water in the tank (C), no water.
NOTE: The concentration of mist may be slightly different, which is normal. Different types of water, humidity,
temperature and air momentum affect the spray intensity.
9.Before replacing with another oil, please clean the unit according to the maintenance instructions.
10. Never leave water in the tank (C) and disconnect the USB cable (K) when the device is not in use.
11. After prolonged operation, turn off the device for 60 minutes to avoid damaging the ultrasonic wave atomizer, and
then restart it.
ACCIDENTAL LEAKAGE
If you accidentally tip the device over during use, follow these steps:
1. Turn off the power. Unplug the unit and open the lid (B) to pour out all remaining water from the water tank (C).
2. Gently shake the unit to drain the internal water.
3. Air dry the device in a safe place for 24 hours.
DISINFECTING
If water-induced limescale builds up in the fragrance diffuser, you can add white vinegar to the water to dissolve the
limescale, let it sit for 20 minutes, and then rinse with water. Then use a soft cloth to wipe off the water. Never use
strong cleaning agents.
TROUBLESHOOTING
If this product does not work normally, please follow the following steps to troubleshoot the problem yourself before
sending it back to the seller:
PROBLEM 1: The product automatically shuts down within one second when the spray button N is turned on.
POSSIBLE CAUSE: Inadequate amount of water.
SOLUTION: Please add water to the water tank or pour if it exceeds the MAX level.
POSSIBLE CAUSE: USB cable is not connected to the device.
SOLUTION: Make sure the USB cable is connected to the product and to the power source properly.
PROBLEM 2: No atomization or abnormal atomization
POSSIBLE CAUSE: Inadequate amount of water.
SOLUTION: Please add water to the water tank if there is not enough water. If the water level in the center of the
water tank is higher than the maximum water level mark, the mist will spray irregularly, abnormally. Pour off the
water so that it is below the "MAX" level.
POSSIBLE CAUSE: The ceramic plate of the atomizer (I) is dirty.
SOLUTION: Please clean the water tank (C) and the ceramic atomizer plate (I).
POSSIBLE CAUSE: The holes of the lower air inlet (G) are dusty.
SOLUTION: If the air inlet holes (G) are dusty, the volume of air drawn in will decrease significantly, and the air
momentum will not be enough to atomize the mist. Clean the air inlet.
5