RUSTA Multistyler 6 in 1 HMS24 Gebrauchsanweisung Seite 9

Roll the volumizer outwards from the roots to the ends to engage the bristles
and gently grip the hair.
Finally, switch to the cold mode to set your style.
CURLERS, LEFT & RIGHT – AUTO CURLERS
Automatically wrap hair around the barrel by air power.
Right and left barrles to create curls in both directions.
Begin with 80–90% dry hair.
Select the direction of the curls by choosing the right or left curler barrel.
Hold a 1.5–2.5 cm section of hair, 10 cm from the ends making sure to
let the ends hang freely.
Turn on the multistyler.
Bring the styler behind the ends of the hair and let the ends wrap around
the middle of the barrel automatically. Once the ends wrap, let go of the hair
section and slowly bring the barrel directly to the roots, allowing the hair to
continue to wrap itself around the barrel. No need to twist. For best curling
results and to avoid heat damage, hold the barrel in place for 10 seconds
then switch to cool mode for at least 10 seconds. Repeat until hair is dry
for best results. Turn off the multistyler and pull the barrel straight down
to reveal your curl!
CAUTION!
Always be careful when removing the attachments
as they can be very hot and cause burns.
CARE AND CLEANING
Clean the air inlet and outlet to prevent blockages that may cause overheating.
The hair styler should be cleaned at least once a month.
SELF-CLEANING MODE
After running in cold air mode, turn off the product and long press SET mode button
for 5–7 seconds to start self-cleaning mode. Self-cleaning will be automatically turned
off in 15 seconds, or you can pull out the plug to stop it.
1. Always turn the ON/OFF button to 0 and pull out the plug from the power outlet
before you clean the main device.
2. Let the multistyler cool down – do not touch any hot parts.
3. Remove the attachments from the main device.
4. Do not use corrosive or abrasive agents for cleaning. Never immerse the main
device in water or other liquid.
5. Wipe the main unit with a dry cloth.
6. Keep the air intake filter clean. Remove the filter cover and frequently remove
hair and dust. Dust will adhere to the net.
9