RUSTA Multistyler 6 in 1 HMS24 Gebrauchsanweisung Seite 10

7. To clean the air inlet, remove the filter cover by turning it counterclockwise
direction and pull the cover down towards the supply cord. Remove dust or hair.
8. To re-attach the filter, ensure that the groove of the connector and the projection
of the cover are in line. Twist to fit.
9. Store in a dry, dust free environment.
CAUTION!
• Do not put your hands on the air outlets or use them if they
are damaged. You may get burned.
• Only use the multistyler for drying and styling human hair.
Do not use it for children.
• Do not use the multistyler if it is damaged.
• Do not touch the attachments as they become hot during
and after use.
• Make sure hair does not get sucked into the air inlets.
• Do not use thinner, benzene or any other solvent to clean
the hair style.
• This hair styler is equipped with an automatic overheating
protective device. If the multistyler overheats, it will generate
cold air. Unplug it from the power socket. Allow it to cool down
for a few minutes before using it again. Check that no fluff,
hair etc. is in the air inlets and outlets before switching
it on again.
REPAIRING THE MULTISTYLER
1. Do not attempt to repair, disassemble or modify the multistyler by yourself.
2. If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
3. If the cord or plug is damaged, stop using it immediately and contact an authorized
service center.
10