Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Setting a Disc
1
Open the disc tray
Press the eject button and slowly pull out the tray.
2
Place a disc
Place the disc with the label facing upward in the
drive and push down until the center holder clicks.
<Removing a disc>
Place a finger on the center holder and lift up on the
edge of the disc.
Close the disc tray
Close the tray without touching the eject button.
Label side up
Eject Button
(This illustration features
CF-72 series.)
• Do not apply excessive force to the tray in the open position, doing so could damage
the tray.
• cUsing PC Cards>
If the PC Card does not work, there may be no interrupt request (IRQ) line available.
Deactivate unnecessary equipment using in the Setup Utility.
Inotej-
• References to "CD-ROM" in the Setup Utility will not change when the DVD-ROM
Drive Pack is installed.
• If the vibration of the DVD-ROM drive is excessively high, use the Setup Utility to
reduce the CD-ROM or DVD-ROM drive speed (by setting it to [Low] or [12x
speed])*.
* This setting
does not work for
the
DVD-ROM
disc
when
this drive is
used
with the
CF-71
8
Werbung
