UNIPRODO ACENDER 2.0 Bedienungsanleitung Seite 48

1 – Click the confirmation key after the stitch selection is completed and the machine will enter into the
work mode.
A – Confirmation button
2 – Put the thread and the bottom line; put the fabric in place; put down the foot.
3 – Click the start button to start sewing.
4 – Click the cut line after sewing and the automatic section line and bottom line of machine.
5 – Ensure that the needle is lifted at highest position and the cloth is removed to complete the sewing
operation.
The user must correctly use the corresponding function to press the foot, otherwise it may result in
unstitching or breakage of the needle causing injury.
Embroidery preparation
The user must use embroidery to press the foot for embroidery operation, otherwise it will not be
embroidered.
The user should choose the use of embroidery with different embroidery patterns and embroidery
patterns Suitable embroidery thread, the embroidery thread of different specifications and sizes is not the
same effect, it is suggested that the user should use qualified embroidery thread
EN
B – Start button