Preparing For Use - Uniprodo Acender 2.0 Bedienungsanleitung

Accessories
Locking
Zigzag seam
intraocular
presser foot
pressure foot
Embroidery
presser foot knife/brush
Tweezers
3.2.

Preparing for use

APPLIANCE LOCATION
The temperature of environment must not be higher than 40°C and the relative humidity should be less
than 85%. Ensure good ventilation in the room in which the device is being used. There should be at least
10 cm distance between each side of the device and the wall or other objects. The device should always be
used when positioned on an even, stable, clean, fireproof and dry surface, and be out of the reach of
children and persons with limited mental and sensory functions. Position the device such that you always
have access to the power plug. The power cord connected to the appliance must be properly grounded
and correspond to the technical details on the product label.
A – Start/Stop button
B – Back seam button
C – Cutting button
D – Pointing button (needle up and down)
Zipper presser foot
Cutting
Screwdriver
Stylus Scissors
EN
Line cap big, medium small
Needle
Embroidered
frame
The bobbin Wrench
Embroidered
Roll line
frame