Installing The Devices - eQ-3 MAX! Cube Bedienungsanleitung

Browser:
In order to enable communication between MAX! com-
ponents, the devices have to be taught in to one another.
The devices should be installed room by room and, within
rooms, one device at a time. To do this, proceed as follows:
If you have already used the single room solution
with a MAX! Wall Thermostat, please restore the
factory settings of all devices before teaching in to
the MAX! cube. For further details, please see the
corresponding operating manual.
• Install the device that you want to teach in on the MAX!
system (e.g. MAX! radiator thermostat) by following the
instructions in the relevant operating manual.
• Select „New device" in the software to switch the MAX!
cube to teach-in mode.
• Set the device that you want to teach in on the MAX! sys-
tem (e.g. MAX! radiator thermostat) to teach-in mode by
following the instructions in the relevant operating manual.
• The device appears in the software.
• In the software, click „Next".
• Assign a name for the device. Allocate the device to
a room.
• Follow the same procedure for all the other devices that
you want to teach in on the MAX! system.
Internet Explorer® Version 7.0 or higher,
Mozilla Firefox® Version 3.6.16 or
higher, Safari Version 5 or higher,
Google Chrome Version 8 or higher

6.3 Installing the devices

21