NetApp AFF A300 Handbuchaktualisierung Seite 138

device
(boot_after_controller_replacement) Boot after controller upgrade
(boot_after_mcc_transition)
(9a)
their ownership information.
(9b)
initialize node with partitioned disks.
(9c)
initialize node with whole disks.
(9d)
(9e)
The boot device has changed. System configuration information could
be lost. Use option (6) to restore the system configuration, or
option (4) to initialize all disks and setup a new system.
Normal Boot is prohibited.
Please choose one of the following:
(1) Normal Boot.
(2) Boot without /etc/rc.
(3) Change password.
(4) Clean configuration and initialize all disks.
(5) Maintenance mode boot.
(6) Update flash from backup config.
(7) Install new software first.
(8) Reboot node.
(9) Configure Advanced Drive Partitioning.
(10) Set Onboard Key Manager recovery secrets.
(11) Configure node for external key management.
Selection (1-11)? boot_after_controller_replacement
This will replace all flash-based configuration with the last backup
to disks. Are you sure you want to continue?: yes
.
.
<output truncated>
.
.
Controller Replacement: Provide name of the node you would like to
replace:<nodename of the node being replaced>
Changing sysid of node node1 disks.
Fetched sanown old_owner_sysid = 536940063 and calculated old sys id
136
Boot after MCC transition
Unpartition all disks and remove
Clean configuration and
Clean configuration and
Reboot the node.
Return to main boot menu.