Battery Installation - Panasonic EY37A2 Bedienungsanleitung

WARNING:
• Do not use other than the Panasonic battery
packs that are designed for use with this
rechargeable tool.
• Panasonic is not responsible for any damage
or accident caused by the use of the recycled
battery pack and the counterfeit battery pack.
• Do not dispose of the battery pack in a fire, or
expose it to excessive heat.
• Do not drive the likes of nails into the battery
pack, subject it to shocks, dismantle it, or
attempt to modify it.
• Do not allow metal objects to touch the battery
pack terminals.
• Do not carry or store the battery pack in the
same container as nails or similar metal
objects.
• Do not charge the battery pack in a high-
temperature location, such as next to a fire or
in direct sunlight.
Otherwise, the battery may overheat, catch
fire, or explode.
• Never use other than the dedicated charger to
charge the battery pack. Otherwise, the battery
may leak, overheat, or explode.
• After removing the battery pack from this
product or the charger, always reattach the
pack cover. Otherwise, the battery contacts
could be shorted, leading to a risk of fire.
• When the Battery Pack Has Deteriorated,
Replace It with a New One.
Continued use of a damaged battery pack may
result in heat generation, ignition or battery
rupture.
• If you detect any abnormalities, discontinue
use immediately and contact the retailer from
which you purchased this product.
• Do not turn the volume up too high when using
headphones or earphones.
• Be careful not to raise the volume as your
hearing adapts.
• Do not use this product over a long period
of time, and always take a break to rest your
ears.
• If you experience any discomfort to your ears,
discontinue use and contact your physician.
• Do not place heavy objects on the radio or
climb on top of it.
• Do not place the radio on an unstable surface
or in an unstable position.
• Be sure to always back up the data saved in
the device connected to this radio to prevent
the loss of data in the event of a device failure.
EY37A2.indb 9
II. ASSEMBLY

Battery Installation

NOTE:
If the batteries are removed from both the
main battery pack compartment and back
up battery compartment, initialization will
be performed about three minutes later.
Installing back up batteries [Fig. 1]
1. Pull out the battery compartment locker to
release battery compartment. There are
main battery pack compartment and back up
battery compartment.
2. Remove back up battery compartment cover
and insert 2 fresh UM-3 (AA sizes). Make
sure the batteries are with correct polarity as
shown inside the compartment. Replace the
battery cover.
NOTE:
• The radio can be used without connecting
the backup battery.
• Keeping back up batteries inside the
compartment prevent stored data in
preset memories from being lost.
CAUTION:
• Do not use any batteries other than those
specified (UM-3).
• Remove batteries if product is not to be
used for a long time.
• Do not mix new batteries with old ones or
use different types of batteries together.
Improper use of batteries may result in
battery leakage, heat generation, fire or
explosion.
If any fluid is leaking from the batteries,
pay careful attention to the following
safety points.
• Never touch battery fluid with your bare
hands. Doing so could result in a skin
inflammation or an injury.
• Blindness could result if the fluid gets in
your eyes.
• Completely wipe up any spilled battery
fluid.
Attaching/Removing main battery pack
[Fig. 2]
1. After back up batteries are inserted, insert
the main battery pack to the main unit.
Always insert it all the way until it locks
in place with a little click. The suitable
battery packs for this radio listed in the
Specifications.
- 9 -
EN
2015-2-11 17:07:24