Declaration Of Conformity (Doc) - Panasonic EY37A2 Bedienungsanleitung

Declaration of Conformity (DoC)

Hereby, "Panasonic
Corporation" declares
that this product is in
compliance with the essential requirements and
other relevant provisions of Directive 1999/5/EC.
ONLY FOR U. K.
VII. ELECTRICAL PLUG
INFORMATION
FOR YOUR SAFETY PLEASE READ
THE FOLLOWING TEXT CAREFULLY
This appliance is supplied with a moulded three
pin mains plug for your safety and convenience.
A 5 amp fuse is fitted in this plug.
Should the fuse need to be replaced please
ensure that the replacement fuse has a rating of
5 amp and that it is approved by ASTA or BSI to
BS1362.
Check for the ASTA mark
on the body of the fuse.
If the plug contains a removable fuse cover you
must ensure that it is refitted when the fuse is
replaced.
If you lose the fuse cover the plug must not be
used until a replacement cover is ob-tained.
A replacement fuse cover can be purchased
from your local Panasonic Dealer.
IF THE FITTED MOULDED PLUG IS
UNSUITABLE FOR THE SOCKET OUT-LET IN
YOUR HOME THEN THE FUSE SHOULD BE
REMOVED AND THE PLUG CUT OFF AND
DISPOSED OF SAFELY. THERE IS A DANGER
OF SEVERE ELECTRICAL SHOCK IF THE
CUT OFF PLUG IS INSERTED INTO ANY 13
AMP SOCKET.
If a new plug is to be fitted please observe the
wiring code as shown below.
If in any doubt please consult a qualified
electrician.
EY37A2.indb 19
Customers can download a copy of the original
DoC to our R&TTE products from our DoC
server:
http://www.doc.panasonic.de
Contact to Authorised Representative:
Panasonic Testing Centre, Panasonic Europe
Ltd. - Hamburg office, Winsbergring 15,
22525 Hamburg, Germany
As the colours of the wire in the mains lead
of this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows.
The wire which is coloured BLUE must be
connected to the terminal in the plug which is
marked with the letter N or coloured BLACK.
The wire which is coloured BROWN must be
connected to the terminal in the plug which is
marked with the letter L or coloured RED. Under
or the BSI mark
no circumstances should either of these wires
be connected to the earth terminal of the three
pin plug, marked with the letter E or the Earth
Symbol
How to replace the fuse: Open the fuse
compartment with a screwdriver and replace the
fuse and fuse cover if it is removable.
This apparatus was produced to BS800.
- 19 -
IMPORTANT:
The wires in this mains lead are coloured
in accordance with the fol-lowing code:
Blue: Neutral
Brown: Live
.
Fuse Cover
EN
2015-2-11 17:07:28