Norm Selection; Install External Microphone; Quick Start Guide; Basic Operation - Radioddity Cb-27 Bedienungsanleitung

Visit Radioddity.com For Downloads
transmit the sound, automatically stop scanning,
3. When the channel signal disappears or decreases
radio will continue to scan. Short Press [A/F] key again or press transmit will exit scan mode.
• Norm Selection
This CB radio supports multiple frequency
is operated, it may be necessary to choose a different frequency
available for European version.
I. For changing the current norm, please hold [A/F] key while turning the radio on. The current
norm appears in the display.
2. Use the channel selectors [UP] and [DN] keys of the microphone
3. Confirm your selection by turning the radio off and on again.
For further frequency band information see Appendix
Regarding the permissions and restrictions
countries, please check the radio passport,
is solely responsible for the selection of the permissible
• Install External Microphone
The microphone is fixed to the radio, it cannot be removed.
the channel selectors [UP] and [DN] keys.
And Help
and maintain the current channel.
to not meet SQ/ASQ requirements,
bands. Depending on the country in which the device
band. This function is only
to set a different norm
C.
of the individual norms in the various European
which is included in the scope of delivery. The user
norm in the country of operation.
It contains the PTT key, as well as
14 Visit Radioddity.com
Align the microphone
the CB with an impedance
turns off the built-in speaker
• Quick Start Guide
1. Open the box carefully and remove the radio, the cable and the microphone.
2. Connect the SO-239 socket of the radio to a corresponding
You will need to purchase
3. Connect the power supply cable to an appropriate
This should be able to supply at least 5A continuous
4. Turn ON/OFF switch
5. Use the channel
The actual channel
6. Press the [PTT] key and talk to her! If necessary,
built-in speaker.
The Radioddity CB-27 is a cost-effective
analog radio but without spending
sure that you are on the same channels
For Downloads And Help
connector with the jack on the front of the radio. An external microphone
of 8Q can be connected to the 3.5mm mono connector.
Chapter

3 - Basic Operation

an antenna to operate the radio.
12V DC power source.
current.
clockwise and set the volume to a medium
selector keys [UP] and [DN] at the microphone
is displayed on the LCD.
use VOL knob to adjust the volume of the
CB analog radio. It can communicate
an exorbitant amount of money on it! You only need to make
with the same modulation
15
This automatically
antenna via a PL-259 plug.
level.
for channel selection.
with any other CB
type.