Adjusting The Volume; Selection; Squelch Setting - Radioddity Cb-27 Bedienungsanleitung

Visit Radioddity.com For Downloads
• Power ONIOFF the Radio
I. Turn [VOL] switch clockwise to power on the radio, the LCD displays the Norms and then
displays channel number.
2. Turn [VOL] switch counter-clock-wise until you hear a click. The radio is powered
• Adjusting the Volume
To turn up the volume, turn the volume clock-wise.
To turn the volume down, turn the volume counter-clock-wise.
as you may inadvertently turn your radio off.
• Channel

Selection

Use the channel selector keys [UP] and [DN] keys at the microphone
The actual channel is displayed on the LCD. For communication,
same modulation type AM/FM has to be selected.
1. Short press [UP] key to change CB channels.
Long press [UP] key for a few seconds and release, channel will increase by I per second.
2. Likewise, short press [DNI key to decreased
long press [DN] key for a few seconds and release, channel will decreased
And Help
off.
Be careful not to turn it too far,
for channel selection.
the same channel and the
Channel will increase by 1;
by 1;
by I per second.
10 Visit Radioddity.com
• Squelch Setting
SQ_SQ: Signal strength
This function is used for squelch level setting, but it detects the strength of received signal, and
better strength means a better signal. It is divided into 29 levels (0-+2.8),
and 2.8 is the highest level. For example,
on when the received signal reaches its maximum.
range of SQ_SQ is obviously
choice, as SQ-SQ and SQ-ASQ can't work at the same time. One will stop working when the
other one is running.)
Operation instructions:
I. Enter: short press the SQ button, the screen displays
the current SQ level. At this time, the SQ level can be adjusted by pressing UP and DN.
2. Exit: After the adjustment
or you can automatically
while without any operation
SQ_ASQ: Noise monitoring
This function is also used for squelch level setting, but it detects the noise of received
and the smaller the noise, the better the signal. It is divided into 9 levels (A149),
lowest level, and A9 is the highest level.
For Downloads And Help
monitoring squelch setting
when set to 2.8, the audio channel can only be turned
(In an experiment,
larger than SQ_AQ. We recommend using SQ_SQ
"sq" for one second, and then display
is completed, you can press SQ again to exit the SQ setting mode,
exit the SQ setting mode and enter the waiting mode. Keep it for a
will also exit the SQ setting..
squelch setting.
O.F is the lowest level,
the noise adjustment
as the first
signal,
A1 is the