Electrolux GK78TSIPCN Benutzerinformation Seite 16

Correct cookware position:
To use this mode you have to place the
cookware on the four connected sections. If
you use cookware smaller than three sections
the control bar blinks and after 2 minutes the
zone switches off.
Incorrect cookware position:
6.5 PowerSlide
This function allows you to adjust the
temperature by moving the cookware to a
different position on the induction cooking
surface.
The function divides the vertical cooking area
into three areas with different heat settings.
The hob detects the position of the cookware
and adjusts the heat setting accordingly. You
16 ENGLISH
can place the cookware in the front, middle,
or rear position. If you place the cookware in
the front you get the highest heat setting. To
decrease it, move the cookware to the middle
or the rear position.
Use only one pot when you operate the
function.
If you want to change the heat setting, lift
up the cookware and place it in a
different position on the area.
• Use cookware with the minimum bottom
diameter of 160 mm.
• If you place the pot in the front position,
lights up on the control panel. The control
bar displays the default heat setting
• If you place the pot in the middle position,
lights up on the control panel. The
control bar displays the default heat
setting .
• If you place the pot in the rear position,
lights up on the control panel. The control
bar displays the default heat setting
1. Touch to activate the function.
The indicator comes on and the control bar
displays the default heat setting.
.
.