Adding New Oil; Recycling Used Oil; Drain New Oil; Draining Used Oil - Autool Atf705 Bedienungsanleitung

Adding When the vehicle's automatic transmission fluid level is insufficient,
new oil and a certain amount of new oil needs to be added to the rated value,
you can run this function.
●
●
Recycling When you need to recycle the used oil from the vehicle's automatic
used oil transmission back into the equipment, you can run this function.
●
●
●
Drain new
oil
●
Draining ●
used oil
●
Do not add new transmission fluid to the tank midway through this func-
tion's operation, as this will result in unequal amounts! If new fluid does
need to be added, wait until this function has finished running.
Select the "Add New Oil" function and set the amount to be added.
Select start to confirm and begin the exchange. The interface dynamical-
ly displays relevant parameters in real time.
Important Tips
The set amount to be added must not be larger than the amount of oil in
the new oil tank; otherwise, the machine will not operate.
Do not start the engine.
Select the "Recycle Used Oil" function and set the amount to be recycled.
Start the vehicle's engine, select start to confirm and begin the exchange.
The interface dynamically displays relevant parameters in real time.
Select the "Drain New Oil" function, at which point the equipment's oil
hoses must not be connected to the vehicle.
Select start to confirm and begin the exchange. The oil from the new oil
tank will be drained into the old oil tank.
Open the equipment's back door, loosen the fixed strap on the old oil
tank, remove all hoses from inside the old oil tank, and remove the old oil
tank from inside the equipment. Drain the old oil.
After draining, properly place the empty old oil tank on the weighing pan,
insert the hoses, and secure them with straps.
10