AENO RC7S Schnellstartanleitung Seite 11

3. Attach the side brush (Fig. C-2).
4. Place the charging base on a flat, stable, horizontal surface as shown in Fig.
C-3, and connect the base to the power supply: plug the power cord jack
into the connector on the base and the plug into a power outlet.
5. Place the vacuum cleaner on the charging base by connecting the charging
contacts on the vacuum cleaner to the contacts on the base (Fig. C-4): the
LED indicator will start flashing white, the charging will start. When
charging is complete, the indicator will turn solid white.
Note. The first charge takes up to 6.5 hours.
Manual Control
ATTENTION! Remove all hazardous objects from the floor before operating the
vacuum cleaner (see "Limitations and Warnings"), power cords, valuables.
Press and hold the "Start/Stop" button for 3 seconds to turn the device on. The
vacuum cleaner will go into standby mode. Select the type of cleaning:
Dry Сleaning. Press the "Start/Stop" button once to start cleaning.
Dry and Wet Cleaning. Follow the steps below to start dry and wet cleaning:
1. Remove the container 2 in 1 from the body of the vacuum cleaner (Fig. D-1).
2. Fill the water tank with purified water to at least 2/3 of its volume (Fig. D-2).
3. Attach the fabric cover to the module. Attach the fabric cover module to the
container (Fig. D-3).
4. Insert the container back into the body of the vacuum cleaner (Fig. D-4).
5. Start cleaning by pressing the "Start/Stop" button once.
Note. You can interrupt cleaning by pressing the "Start/Stop" button again.
If no action is performed for 10 minutes, the vacuum cleaner will enter sleep
mode and all indicators will turn off. Press the "Start/Stop" button again to
resume cleaning.
Note. The vacuum cleaner automatically returns to the base to charge after
cleaning is complete and when the battery is low. After charging, the
cleaner resumes cleaning from where it was interrupted.
Connecting the Device to the Application
Note. It is recommended to stay as close as possible to the vacuum cleaner
and, if possible, to the Wi-Fi router while the device is connected to the
application.
aeno.com/documents 11