Noises - AEG A82630GNW3 Benutzerinformation

36 www.aeg.com
2
1
11. Remove the covers on the handles
carefully with a small screwdriver.
12. Unscrew the handle.
13. On the opposite side remove the
hole covers by driving a 3-4 mm drift
or drill into them.
14. Install the handle.
15. Install the covers on the handle.
16. Install the hole covers provided
within the accessory bag.

9. NOISES

There are some sounds during normal running (compressor, refrigerant circulation).
4
3
17. Raise the appliance and install the
ventilation grill.
18. Put the cabinet in position.
CAUTION!
Reposition, level the
appliance, wait for at least
four hours and then connect
it to the power socket.
Do a final check to make
sure that:
• All screws are tightened.
• The magnetic seal
adheres to the cabinet.
• The door opens and
closes correctly.
If the ambient temperature
is cold (i.e. in Winter), the
gasket may not fit perfectly
to the cabinet. In that case,
wait for the natural fitting of
the gasket.
In case you do not want to
carry out the above
mentioned operations,
contact the nearest
Authorised Service Centre.
The Authorised Service
specialist will carry out the
reversibility of the doors at
your cost.