How To Assemble; How To Use - Lionelo Rina Bedienungsanleitung

G. Control panel
H. USB cable
Control panel (fig. D)
1. ON/OFF key
2. Volume down / rocking speed down
3. Volume up / rocking speed up
4. Rocking OFF / automatic motion detection OFF
5. Timer – 8 / 15 / 30 minutes
6. Play / select / deactivate melodies
7. Time indicator
Remote control (fig. E)
1. ON/OFF key
2. Timer
3. Play melody
4. Volume down
5. Volume up
6. Resume / stop melody
7. Next melody
8. Previous melody
9. Stop rocking
10. Keys from 1 to 5: select rocking speed

How to assemble

1. Insert and screw aluminum feet to the base of the infant swing with screws (A, fig. 1a).
2. Put the support into the base of the infant swing (B, fig. 1a). Pay attention to proper
position of the shank – its truncated part must face the back of the chair (fig. 1b).
3. Insert the frame of the infant swing into the support on the base (C, fig. 1a). Make
sure the metal fasteners are in a right place. If you can hear a click, it means that the
installation is correct.
4. To remove the support from the base of the infant swing, press the button at the back
of the support (A, fig. 3) and pull it up.
5. Put the covering on the product, remember to fasten with Velcros.
6. To attach the bow, slide it into a relevant plastic hole in the upper part of the infant
swing. To remove the bow, pull it out after you have slid the button (fig. 7).

How to use

When the installation is finished, connect the product to the source of power or insert
batteries (fig. 2).
EN ‑ 8 ‑