Blitz Automatic 4 Betriebsanleitung Seite 12

12
Operating Instructions
Operation
6. Faults, causes, remedies
Fault message E-1
Cause
Fall short of the minimum supply pressure
(7/12bar)
Fault message E-4
Cause
Tyre valve is not open
Filling hose is kinked
Fault message E-5
Cause
Environmental pressure compensation is not
possible
Filling hose is kinked
Fault message E-6, E-8, E-9
Cause
Defect of the pressure transformer
Fault message LO
Cause
Supply voltage too low
Fault message E-11
Cause
Supply voltage too high
Fault message E-12, E-13
Cause
Defective controls
Remedy
Check the supply pressure, and set, if and
when necessary (min. 7/12bar;max. 16bar)
Remedy
Remove valve plug and connect again
Check the filling hose
Remedy
Open the valve plug
Check the filling hose
Remedy
Notify the Service Department
Remedy
Check supply voltage
Remedy
Check supply voltage
Contact service
Remedy
Contact service
120335 04/14