General Notes - S+S Regeltechnik Thermasreg Rtr-B Bedienungs- Und Montageanleitung

@

General notes

Our "General Terms and Conditions for Business" together with the "General Conditions for the Supply of Products and Services of the Electrical
and Electronics Industry" (ZVEI conditions) including supplementary clause "Extended Retention Of Title" apply as the exclusive terms and conditions.
In additionln addition, the following points are to be observed:
These Instructions must be read before installation and putting in operation and all notes provided therein are to be regarded!
Devices must only be connected to safety extra-low voltage and undar dead-voltage condition. To avoid damages and errors the device
(e.g. by voltage induction) shielded cables are to be used, laying parallel with current-carrying
ba observed,
This device shall only be used for its intended purpose. Respective safety regulations issued by the VDE, the states, their control authorities,
the TUV and the local energy supply company
prevent perils of any kind.
No warranties or liabilities will be assumed for defects and damages arising from improper use of this device.
Consequential damages caused by a fault in this device are excluded from warranty or liabilty.
These devices must be installed by authorised specialists only.
The technical data and connecting conditions of the mounting and operating instructions
valid. Deviations from the catalogue representation
improvement of our products.
- In case of any modifications made by the user, all warranty claims are forfeited.
This device must not be installed close to heat sources (e.g. radiators) or be exposed to their heat flow. Direct sun irradiation or heat
irradiation by similar sources (powerful lamps, halogen spotlights) must absolutely be avoided.
Operating this device close to other
This device must not be used for monitoring applications, which serve the purpose Of protecting persons against hazards or injury,
or as an EMERGENCY STOP switch for systems or machinery, or for any other similar safety-relevant purposes.
Dimensions of enclosures or enclosure accessories may show slight tolerances on the specifications
Modifications of these records are not permitted.
- In case of a complaint, only complete devices returned in original packing will be accepted.
These instructions must be read before
must be observed. The purchaser
are not explicitly mentioned and are possible in terms Oftechnical progress and continuous
devices that do not comply with EMC directives
installation and putting in operation
lines is to be avoided, and EMC directives are to
has to adhere to the building and safety regulations
delivered together with the device are exclusively
may influence functionality.
provided in these instructions.
and all notes provided therein
and has to
are to be regarded!