SCANGRIP UNI-EX 03.5600 Bedienungsanleitung Seite 3

3. Usageand Application Scope
UNI-EX 03 5600 Of Handheld Rechargeable Work Light is a rechargeable and portable explosion proof handle light
(abbre.Explosion-proof light in the followinginstruction),suitablefor usinginexplosiveareaOfZoneO,Zone zone2,
Zone20,Zone21, zone22, gasgroup All
t is suitable for using in temporary local auxiliary lighting and local main lighting for the industries Of petroleum
produce, smelting, chemical, pharmaceutical, brewing, military reserve, etc.
4. INSTRUCTION
• Before use, please check whether the packing is in good condition, if there is any visible damage of the light and
charging base. For the handle light, please check if there is any visible damage of the structure or "abnormal sound"
inside. Please open the light to check if the damage will influence the explosion-proof performance and make
appropriate treatment.
• Please check if the explosion-proof light nameplate parameters listed are conformed to the actual conditions of
use.
• The explosion-proof light is composed of handle light, charging base and adaptor.
The explosion-proof light is with magnetic base, foldable stand and hook. It can be adjusted in different direction
and easily, quickly use with the hook.
• The explosion-proof light is with four modes; Top, Low, High, OFF. Press first "Top", second "Low", third "High",
fourth "OFF",
• Please charge the light under the circumstance between 00 Cto •450 C. Please pay attention to the orders when
charging. First, please make sure the effective connection between the light and charging base. Second, plug the
adaptor to AC power supply. The conversed operation
• The explosion-proof light is with the function of battery capacity indicating. Press the "switch" for 3 seconds,
"battery capacity indicator"
time. When it show5 "("Ä@"symbol, the charging is finished and please disconnect the AC power supply.
• The following operations are prohibited in any possible dangerous area:
Open the light Whenit is working or turning Off the load.
Regular or occasional maintenance and repair.
Operating under explosive atmosphere, fasten protection cap Of charger, do not open the protection cap under
explosive atmosphere.
• The persons Who use the light at site should know about the performance Of explosion proof light. Turn Off the
light in time and evacuate the dangerous area Whenfind any abnormal phenomenon. Unqualified repair person is
not allowed to repair the explosion-proof lights.
5. MAINTENANCE
• When installation, use and maintenance, observe following standards IEC6007 g 10, IEC6007g 14, IEC6007g 17
and IEC 60079 19
• The service man must have on the-job training to know the specification and operating performance Of
explosion-proof light. They must have professional knowledge and should familiar With the structure Of explosion
proof light.
• Clean the dust and dirt on the shell Of the explosion-proof light regularly to improve the luminous efficacy and
heat dispersion performance. A wet cloth can be used for cleaning.
• Check whether the transparent parts have been impacted by foreign body regularly. Check whether the
fasteners and inner components are loose, soldering off or corroded. f yes, do not use it until maintained.
If use the light in damp environment, please regularly check and change the sealing components to ensure the
protective performance Of the shell.
• When disassemble the light, must comply With the warning requirements to operate in non-dangerous area.
• After open the shell, should check Whether the sealing components become hard or adhesive; whether the
insulating layer of the wire become green or carbonized; whether the insulating parts
and electrical components become deformed or have scorch. If these problems are found, must repair the light
immediately,
• The model, specification, dimension and performance of the parts for maintaining should keep the same as the
original ones,
• Check whether the sealing ring is at the original location by achieve the sealing function when close the shell.
• Do not disassemble the sealing parts of the light often. Otherwise the explosive proof function will be affected.
C,dust groupI All
prohibited.
show the current battery capacity. When it shOw5
CandTemperatureGroupTI-T4/T120 'C.
symbol, please Chargein