NORAUTO MICRO START Hinweise Zur Bedienung Seite 81

HOW TO JUMP START YOUR CAR
WE STRONGLY SUGGEST TO VERIFY THE VOLTAGE
OF THE CAR BATTERY IS 12V BEFORE STARTING. IF
IT IS BELOW 2V OR ABOVE 12.6V, IT CAN'T BE JUMP
STARTED.
WARNING: When using this unit to start, make sure the
positive and negative connections are correct, otherwise the
battery may explode.
1
Press and hold the power
switch (6) for 3 seconds to
turn on the unit. Make sure the
battery level is over 50%.
3
GREEN
GREEN
After the connection is
completed, a green light (10)
on the SSC case (12) will
indicate the correct status to
jump start. Start the car and
do not crank over 5 seconds.
50%
3 seconds
3 Seconds
ON
ON
OFF START
OFF START
2
1 2
Follow the steps below for
jump start, otherwise it could
be dangerous:
1. Connect the red (+) clamp
to the positive (+) battery
terminal.
2. Connect the black (-) clamp
to the metal part of the
engine (negative ground)
or to the negative battery
terminal.
3. Insert the jump start plug (8)
into the jump start port (1)
of the device.
4
(Standby)
3 2
After the engine is successfully
started, first pull out the jump
start plug (8) of the device and
then remove the clamps from
the car battery.
79
Red
Red
(Standby)
(Standby)
3
Red
1