5_First Steps; Battery; 1_Installing And Extracting The Battery; 2_Charging The Battery - RugGear RG500 Schnellstartanleitung

10

5_firSt StEPS

5.1_battery

The battery is inserted into the back of the phone. The battery
is not fully charged when the phone is purchased, but it contains
enough energy to power on the phone. To obtain best battery
performance and battery life, let the battery discharge completely
before charging it completely for the first three charging cycles.

5.1.1_installinG anD extractinG tHe battery

When installing the battery, insert the teeth at the bottom of the
battery into the corresponding notches of the phone, then put
the battery inside and press the battery down. Next, insert the bat-
tery cover in the same way and secure it by turning the two screws
with the delivered screw driver. Ensure that both – battery and
battery cover – is safely in place before powering on the phone.
Quick Start Quick Start

5.1.2_cHarGinG tHe battery

5.1.3_battery use

In actual use, the standby time and talk time of the phone varies
with the network status, working environment and usage.
When the power of the battery is lower than normal, the phone
will prompt you to charge it. Please charge the battery; otherwise
you may lose any files which have not been saved.
If you do not charge for a long time, the phone will be powered off
automatically.
WarninG
The phone may only be charged at ambient temperatures in
a range from 0 °C – 45 °C. Please do not use charging equipment
if the temperature exceeds this range. Only use the RugGear
approved USB-cable and charger.
Connect the USB-cable with the phone as
indicated in the picture.
Connect the plug with the socket of the
Power Supply.
After charging, remove the USB-cable from
the charger.
11
En